configure secondary ip address on a Fortigate command line

Angelo Schalley
Mar, 16, 2017
Fortigate/Fortinet, Networking
2 Comments

config vdom

edit “vdom name”

config system interface

edit “interface name” (lookup via “show” when in ‘config system interface’ mode)

set secondary-IP {enable | disable}

config secondaryip

edit 1 (or any other number)

set ip <ipv4-classnet-host>

set allowaccess {ping | https | ssh | snmp | http | telnet | fgfm | auto-ipsec}

2 Responses so far.

Rick says:

09/04/2018 at 20:58

How do you setup two IPv6 addresses on the same interface?
Angelo Schalley says:

27/07/2018 at 15:33

Hallo Rick,

It is maybe a bit late but here go’s :

config system interface
edit “interface”
config ipv6
config ip6-extra-addr
edit “IP/Prefix”
end
end
end

regards,
Angelo